Two fluted to give clean finish, nose bearing for routing a rebate, and shank bearing for profiling edge flush.
Ideal for removing damaged trim on tops to enable new trim to be added.
Tungsten carbide tipped (TCT) for abrasive materials and is ideal for use on both manmade board and timber.
Self-guiding with bearing on nose and shank.
Tool diameter 16mm with 14mm diameter bearing nose.
Can be used for material 12mm thick up to 38mm thick maximum.
Standard trim 1mm with 14mm bearing.
Accessory bearings available to fit 1.5mm, 2.5mm and 3mm lipping/edging.